These rings looked like they would fit the bio: lightweight, low cost, and vertical. When I unboxed them, I noticed that one of them had mill marks through the finish where whoever was drilling the top hole missed his/her mark. This is problematic beyond cosmetic, as it shows that the finishing occurs BEFORE the drilling, which means the interior of holes are not finished. When I tried to install them, one of the the bottom allen bolts rounded out under little pressure much less than the 25 lbs. torque I use on most rings.
I would not buy these again. Though the integral mount on this rifle seems to made for rounded Weaver type mounting bolts, I put a set of trusty Warne rings on the rifle, with the squared pegs, and they seem to be holding just fine. Now off to the range for testing...
0 people found this review helpful. Did you?
0 people did not find this review helpful. Did you?